![]() I have three monitors and this problem was driving me nuts (actually irking me every time I woke my PC, and then I'd forget about it). The solution for me was to simply install drivers for my newest monitor. The forced resolution will override detection of the screen and should persist through sleep. However if this is unavailable, you can use the Windows Resolution window to detect devices while the monitor is disconnected, then select the display which will report “Another Display Not Connected”, then under Multiple Displays, you can drop down and select “Try to connect anyway” which will broadcast a signal to the monitor over the port type you have selected (the signal will not be interactive), then connect the display which should interpret the signals sent to it properly. You can usually force the detection of a monitor within the graphics driver control panel. If the issue is still not resolved after updating the drivers, it may be due to an unusually reported display ID (EDID). Update your graphics drivers from the manufacturer to resolve the issue. Usually this will be caused by the graphics driver not properly supporting sleep modes and therefore disabling the ability to detect a connected display when the computer goes to sleep. I don't know why there are three configs, I have only ever used one So for some reason one of the configs does not get set correctly. Moving/resize issue returned, but the lower right corner was set to I changed these to 1600x900 and the problem was solved.įurther I changed resolution (via control panel) to 1920x1080, the The third ( SIMULATED.) were set to 1024x768. Were 1440x900, so they were not involved. Under 00 was another branch also called 00. HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Control\GraphicsDrivers\Configuration ![]() That Windows was accessing the following Registry path: Using Sysinternals ProcessMonitor I found This fixes the issue for me now all my window positions and sizes are preserved. When waking from sleep, all my windows had been pushed to one display, and some of them resized. I'm running Windows 8.1 with two 2560x1440 displays on DisplayPort. This will ensure that only essential services will run.This is an old question, but if anyone arrives here with the same issue, I suggest trying the solution posted here: Next, click the Services tab, check Hide all Microsoft services and select Disable all.Then, type in msconfig to launch System Configuration.If it can, you’ll need to perform a clean boot to narrow down the fault. To check whether this is the case, restart your PC in Windows 10 Safe Mode and see whether it can go to sleep. Sleep mode problems are often caused due to a complication between the hardware and software during startup. If there aren't any, unplug the device and check to see if the sleep problem persists. Go to the manufacturer's website and check for any compatibility issues. Common culprits include printers, scanners, gaming consoles, webcams, and more. ![]() This is because some manufacturers release updates before they’re compatible with the newer version of Windows. Check the Compatibility of Any Attached DevicesĪ device connected to your PC may not be compatible with the latest version of Windows 10. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |